LED DOWNLIGHT · PURE-DS SERIES

PURE-DS DIP Selectable Family

8-24W · 95/145mm cutouts · 3000/4000/6000K — DIP selectable TRIAC downlight for hotels and shops.

Home / Product / Led Downlight / PURE-DS

White PURE-DS DL02-DIP DIP selectable TRIAC downlight for hotel corridors with preset power and CCT

PURE-DS DIP selectable TRIAC downlight in white — preset the wattage and white on site, dim it on the wall dimmer.

PURE-DS DIP selectable downlight front view with deep reflector Black PURE-DS DIP selectable downlight side profile showing trim ring depth

PURE-DS LED Downlight

PURE-DS · 8-24W · 110lm/W · 3000/4000/6000K · UGR<22


The PURE-DS is a CCT selectable TRIAC downlight built in China for hotels and shops, covering 8W to 24W across 95mm and 145mm cutouts — set power and white with the DIP switch at install (8/10/12W in the small housing, 18/20/24W in the large one), then dim the preset output on the existing TRIAC wall dimmer. Made in China by Low Carbon Teclux, one fitting replaces nine stock combinations per housing.

This low glare DIP selectable downlight holds Ra90 with UGR under 22 for corridors, guestrooms, lobbies and retail floors. It is the preset-and-dim answer to the fixed-CCT PURE-S DL02 recessed downlight family, while the PURE-DW dim to warm downlight serves rooms that must end the evening in candlelight.

3000K 4000K 6000K CCT DIP preset 8W 10W 12W 18W 20W 24W
Two DIP banks per fitting — power 8-24W plus white 3000/4000/6000K, set with the power off.
  • 8-24W DIP preset: 8/10/12W small, 18/20/24W large
  • 3000/4000/6000K DIP preset, 110lm/W Ra90 COB
  • UGR<22, COB 24/36/55° beams, TRIAC wall-dim
  • 95/145mm cutouts, 9 trim colors, DL02 housings

Explore PURE-DS DIP Selectable Downlight Family

Preset stock, dimmed light — two housings for every room

The PURE-DS DIP selectable TRIAC downlight pairs DL02 housings with a two-bank preset switch, factory-direct from China. This low glare DIP selectable downlight stocks two fittings to serve corridors, guestrooms, lobbies and shops from 8W to 24W.

One SKU, Nine Combinations

3 powers × 3 whites per housing — stock two fittings

Each PURE-DS fitting carries a two-bank DIP switch inside a die-cast aluminum DL02 housing with an open heat-sink path — one bank sets 8/10/12W in the small housing or 18/20/24W in the large one, the other sets 3000/4000/6000K. Nine combinations per housing.

  • One fitting per housing replaces nine fixed SKUs
  • Contractors dial the site spec at install with the power off
  • Die-cast aluminum cup plus vented trim ring
  • 220~240VAC 50/60Hz, IP20 for indoor ceilings
PURE-DS DIP selectable downlight aluminum housing for heat dissipation

Ra90 True Color, UGR22 Low Glare

110lm/W Ra90 COB in 24/36/55° — stated per CCT

Output is rated at 110lm/W on 4000K: 880-1320lm small, 1980-2640lm large. The 3000K warm step runs about 5-8% lower by phosphor physics and the 6000K step about 3% higher — the datasheet states all three, so quotations never oversell. The COB lens delivers Ra90 accent-grade color deep behind the trim.

  • COB at Ra90, 24/36/55° for corridors, lobbies and shops
  • UGR<22 across every optic, no bare source in view
  • Wattage ±5% plus CCT-stated lumens for honest spacing
PURE-DS DIP selectable COB lens optics for hotel corridor lighting

Retrofit Ready, Dimmer Optional

No new control wire — fixed now, TRIAC later

Running hotels and shops cannot close for rewiring. PURE-DS keeps the installed phase-cut wall dimmers and drops 1:1 into the existing 95mm and 145mm cutouts — DIP presets the ceiling output with the power off, the wall dimmer takes it from there. No signal cable, no apps, no commissioning.

  • 1:1 swap in existing 95/145mm cutouts — old fixed downlight out, preset-and-dim in
  • Runs on installed TRIAC / phase-cut wall dimmers (confirm dimmer model at order)
  • Retrofit rooms and new zones share housings, trims and curves — one visual language
  • Lamp-plus-driver changeover only — ceiling, wiring and business hours untouched
PURE-DS DIP selectable downlight nine trim finishes matching existing ceiling cutouts for retrofit projects

Why PURE-DS for Hotels and Shops

Preset stock, dimmed light from the same DL02 housings

Stock Two Fittings, Serve Every Room

Guestrooms and corridors take the small 95mm housing at 8-12W — lobbies and retail floors take the large 145mm housing at 18-24W, each preset to 3000, 4000 or 6000K on site. All share the same DL02 housings and nine trims, so extended floors read as one family. Start from the LED downlight family index to compare the full range.

The fixed-CCT PURE-S DL02 recessed downlight family stays the choice for projects that never change spec; where ceilings take splashes, use the MIST-P DL03 front-IP44 family instead. Against tunable white (DT8 drivers, wireless mesh), PURE-DS wins on three things:

  • Lower stock cost — one preset fitting per housing, no addressing hardware, no wireless nodes, no commissioning time
  • No rewiring — runs on the existing 2-wire mains plus TRIAC wall dimmers, while DT8 needs two extra signal wires; retrofit and new builds share the same wiring
  • Upgrade means adding one dimmer — if the live wire has no dimmer yet, just add one TRIAC dimmer on it; brightness follows the preset level, no apps or scenes to program
Order optionOutputCRIBest for
DIP small housing880-1320lm, 8/10/12W presetRa90Corridors and guestrooms
DIP large housing1980-2640lm, 18/20/24W presetRa90Lobbies and retail floors
TRIAC dimmingPhase-cut wall dimmerRa90Retrofit and new zones
PURE-DS DIP preset TRIAC driver with power and CCT switch banks for 8-24W downlights

Good to know before you order: DIP presets power and CCT with the power off — the fitting then works two ways. Wire it direct to mains and it runs as a regular fixed downlight at the preset level; add one TRIAC wall dimmer on the live wire when dimming is needed, with no signal wires, no apps and no recommissioning.

Datasheet

Select a size to view full specifications

LC-DL02-DIP-12W
ModelLC-DL02-DIP-12W
WattageDIP 8/10/12W ±5%
Lumen Output880/1100/1320lm at 110lm/W, 4000K rated (3000K approx. -5~8%, 6000K approx. +3%)
Size (Ø x H)Ø105xH42mm
CutoutØ95mm
Light SourceCOB, DIP power + CCT, bevel / curved trim
CCT3000/4000/6000K (DIP preset, power off)
CRIRa90
Beam / GlareCOB 24/36/55°, UGR<22
DimmingTRIAC phase-cut wall dimmer
Voltage / Trim220~240VAC 50/60Hz; 9 colors
LC-DL02-DIP-24W
ModelLC-DL02-DIP-24W
WattageDIP 18/20/24W ±5%
Lumen Output1980/2200/2640lm at 110lm/W, 4000K rated (3000K approx. -5~8%, 6000K approx. +3%)
Size (Ø x H)Ø160xH48mm
CutoutØ145mm
Light SourceCOB, DIP power + CCT, bevel / curved trim
CCT3000/4000/6000K (DIP preset, power off)
CRIRa90
Beam / GlareCOB 24/36/55°, UGR<22
DimmingTRIAC phase-cut wall dimmer
Voltage / Trim220~240VAC 50/60Hz; 9 colors
PURE-DS DIP selectable downlight dimensions 95 and 145mm housings

Variants in series

Two trims, two housings — pick the face by ceiling

White PURE-DS DIP selectable downlight with curved trim for hotel corridors, LC-DL02-DIP-C head

Curved-trim COB — LC-DL02-DIP-xxW-C

Optic type

COB lens, curved trim

CRI / Beam

Ra90, 24/36/55°

Cutout

95 / 145mm by size

Best for

Corridors and guestrooms, DIP preset

White PURE-DS DIP selectable downlight with bevel trim for lobby accent, LC-DL02-DIP-B head

Bevel-trim COB — LC-DL02-DIP-xxW-B

Optic type

COB lens, bevel trim

CRI / Beam

Ra90, 24/36/55°

Cutout

95 / 145mm by size

Best for

Lobbies and retail displays

Lighting Calculator

Estimate how many PURE-DS heads your space needs — simplified estimate without IES

FAQ

Quick answers about the DIP series

Set two switch banks with the power off — 8/10/12W in the 95mm housing or 18/20/24W in the 145mm housing, plus 3000/4000/6000K. One fitting covers nine combinations with no fixed-SKU wall to stock, across the LED downlight family index.

Yes, the preset sets the ceiling and the wall dimmer sets the mood — the DIP switch fixes the maximum output and the existing phase-cut wall dimmer dims that level with no new control wiring. Confirm your dimmer model in the inquiry so the factory matches the smoothest driver batch.

Warm phosphor converts less efficiently — 3000K runs about 5-8% below the 4000K rated lumens, while 6000K runs about 3% above. Quote and space each room by the CCT you actually order; for the full low-end checklist, see the dim to warm lighting guide for restaurants and hotels.

Yes, all nine trims run both housings — matte white, black, silver, matte black, gun black, champagne gold, rose gold and bright silver. Confirm your ceiling finish in the inquiry so the factory kits one color across the 95mm and 145mm cutouts.

Standard warranty is 5 years with spare drivers per shipment, sized from 8W corridors to 24W lobbies in one selectable family.

Application

PURE-DS in shops, lobbies and corridors

Send Message

Fill out the form and we will get back to you as soon as possible